ISSC Block Timer Data

See selector guide to locate models suitable for your application.

Block Timers

Model 2110 Data sheet 1 page, 77k.
2110 timer

An on delay, simple to install, two-wire timer that is compact, encapsulated and three time ranges are available, (0.01-102.3 sec., 1.0-1023 sec., and 10-10230 sec). Time settings are selected by way of a DIP switch. It is available to operate in two voltage ranges, (24-140VAC/DC or 100-240VAC/DC). The output is solid state, N.O., rated at 1 Amp max.

Model 2112 Data sheet 1 page, 77k.

An on delay, simple to install, two-wire timer that is compact, encapsulated and six time ranges are available covering 0.2 seconds to 1000 minutes. Time period is set via an external pot or fixed resistor, optionally factory fixed units are also available. It is available to operate in two voltage ranges, (24-140VAC/DC or 100-240VAC/DC). The output is solid state, N.O., rated at 1 Amp max.

Model 2115 Data sheet 1 page, 77k.
The 2115 is a three-wire interval timer. that is compact and simple to install. It is completely encapsulated and has three time ranges covering from 0.01 to 10230 seconds. A DIP switch sets the desired timeout. It operates anywhere from 100-240VAC and has both UL and CSA approvals. The normally open solid state output is rated at 1 amp continuous.

Model 2120 data sheet 1 page, 77k.
2120 block timer

The 2120 repeat cycle timer features a simple three wire instalation. This compact encapsulated timer has independantly controlable "On Time" and "Off Time" adjustments. Power supply input requires 120 VAC/DC. Solid state output is a reliable 1 amp.

Buy factory direct with your credit card.
Call (800) 233-9354 or (931) 796-3050.
Fax (931) 796-3956
email

Kanson Electronics info@Issc-Kanson.com