ISSC Feature Products Data

See selector guide to locate models suitable for your application.

Feature Products!!!

Model 1248A motion detector Data sheet 2 pages, 116k.

Non-contact self-contained motion detector and proximity sensor in a limit switch style enclosure. Device is 2 wire, operates from 20 to 250 VAC/DC, switching 500 mA and is PLC compatable. A plug-in style connector simplifies installation. Three user selectable ranges cover from 5 to 5000 pulses per minute and an adjustable start time delay of 0 to 20 seconds is provided. Sensing distance is 1/2" with a 40mm x 40mm mild steel target.

Model 2120 data sheet 1 page, 77k.
2120 block timer

The 2120 repeat cycle timer features a simple three wire instalation. This compact encapsulated timer has independantly controlable "On Time" and "Off Time" adjustments. Power supply input requires 120 VAC/DC. Solid state output is a reliable 1 amp.

Model 1017 SP7 Utility Industry timer Data sheet 1 page, 77k.
1017 SP7 untility timer

This on delay timer has been developed with the needs of the electric utilities in mind. It is a rugged device equipped with solid state transient protection and housed in a metal enclosure for maximum noise immunity. The timing dial is available calibrated in 'seconds' or in 'AC cycles' at 60 Hz. The relay output is equipped with magnetic blowouts for switching up to 3A at 150 VDC.

Model 1232 Resistive sensitive switch with on/off delays Data sheet 1 page, 77k.
1232 resitive switch with timers

Output relay operates when sensing probes come in contact with a material which provides a resistance value lower then the set resistance and the on delay time has elapsed. Output relay releases when the resistance between the probes is greater than the set resistance and the off time delay has elapsed. Power supply can be 120 VAC or 24 VAC/DC.

Model 1234 Resistance Range Switch Data sheet 1 page, 77k.
1234 range switch

The 1234 is a window type detector and can be used where fail safe operation is required. Output is operated when sensing probes come in contact with a material which provides a resistance value between the upper and lower set resistances. Output is released when the resistance between the sensing probes is less than the lower set resistance or greater than the upper set resistance. LED indicators show low/good/high conditions. In a typical application the unit could detect a probe shorted to ground(low) or a broke wire to the probe(high).

Model 2115 Interval Block timer Data sheet 1 page, 77k.
2115 block timer

A three-wire interval timer that is compact and simple to install. It is completely encapsulated and has three time ranges covering from 0.01 to 10230 seconds. A DIP switch sets the desired timeout. It operates anywhere from 100-240VAC and has both UL and CSA approvals. The normally open solid state output is rated at 1 amp continuous.

Buy factory direct with your credit card.
Call (800) 233-9354 or (931) 796-3050.
Fax (931) 796-3956
email

Kanson Electronics info@Issc-Kanson.com